Product Type

Dual Door IR Wardrobe Light Sensor Switch

Key Features 

1. Automatic Dual Door Light Control

Smart dual IR sensor automatically switches ON the cabinet light when either wardrobe door is opened and switches OFF only after both doors are completely closed.

2. Ideal for Modern Furniture

Perfect for wardrobes, closets, kitchen cabinets, display cabinets, office furniture, storage cabinets, wooden cupboards and home interiors.

3. Short Range High Accuracy Detection

Built-in infrared technology detects door movement within 5-6 cm, ensuring reliable and accurate switching without manual operation.

4. Energy Saving Operation

Lights remain OFF when both doors are closed, reducing unnecessary electricity consumption and increasing LED lamp life.

5. Easy Installation

Compact controller with dual IR sensors, mounting brackets and simple wiring makes installation quick for furniture manufacturers, electricians and DIY users.

Product Description

Bring convenience and automation to your furniture with the LEYDEN LS-123C Dual Door IR Wardrobe Sensor.

Designed for wardrobes, kitchen cabinets, closets and office furniture, this intelligent infrared sensor automatically turns the light ON whenever one or both cabinet doors are opened.

Unlike ordinary door sensors, the LS-123C keeps the light ON until both doors are completely closed, making it ideal for double-door wardrobes and cabinets.

Its compact design, reliable infrared sensing technology and simple installation make it suitable for residential and commercial furniture applications.

Suitable for:

• Wardrobes
• Kitchen Cabinets
• Wooden Closets
• Display Cabinets
• Office Cabinets
• Furniture Lighting
• Storage Cabinets
• Home Interior Lighting

Technical Specifications

Box Contents

• 1 × LEYDEN LS-123C Control Unit
• 2 × IR Door Sensors
• 2 × Sensor Mounting Brackets
• Installation Guide

Applications

• Home Wardrobe
• Kitchen Cabinet
• Closet
• Display Cabinet
• Office Cabinet
• Wooden Furniture
• Retail Furniture
• Showcase Lighting

Installation Instructions

1. Turn OFF the mains power supply before installation.
2. Install the control unit securely inside the cabinet.
3. Mount both IR sensors opposite the cabinet doors using the supplied holders.
4. Maintain a sensing distance of approximately 5-6 cm between the sensor and the door.
5. Connect AC input and LED light output according to the wiring diagram.
6. Restore the power supply.
7. Open either cabinet door to verify that the light turns ON automatically.
8. Close both doors completely to ensure the light turns OFF.

The datasheet also notes that if higher sensitivity is required, a reflective silver label may be applied to the door surface facing the sensor, and that there should be no obstacles within the sensing area.

Operating Instructions

• Open one wardrobe door → Light turns ON.
• Open both wardrobe doors → Light remains ON.
• Close one door while the other remains open → Light stays ON.
• Close both doors completely → Light turns OFF automatically.

Safety Instructions

• Installation should only be carried out by a qualified electrician.
• Disconnect the mains power supply before wiring.
• Operate only on 220-240VAC, 50/60Hz power.
• Do not exceed the maximum rated load of 200W LED or 5A.
• Suitable for indoor use only (IP20).
• Protect the sensor from water, moisture and direct rain.
• Do not install near excessive heat sources.
• Ensure all wiring connections are properly tightened.
• Do not modify or dismantle the controller.
• Keep the sensing area free from dust and obstructions.
• Replace damaged wiring immediately.

Maintenance

• Clean sensor surfaces using a dry soft cloth.
• Do not use thinner, alcohol or chemical cleaners.
• Check wiring periodically.
• Keep sensor lenses clean for reliable operation.

Warranty

LEYDEN Limited Warranty

• Warranty covers manufacturing defects only.
• Warranty does not cover:
  • Physical damage
  • Water damage
  • Incorrect wiring
  • Overload or short circuit
  • Unauthorized repairs
  • Improper installation
  • Burnt components due to loose connections

Proof of purchase is required for warranty claims.